1. Preparation section. The raw material of the ordinary particleboard production line is shaved, screened and sent to the wood silo for transitional storage. The wood chips are sent to the flaker by a conveyor to prepare the shavings, and the prepared shavings are sent to the wet shaving bin through the transporter for transient storage.
2. Dry sorting and grinding section. The wet shavings are sent to the rotor-type shaving dryer for drying by the conveyor. The dried shavings are sorted (screened) by the shavings. The qualified core shavings are sent to the core dry shaving silo for storage. Excessive shavings are polished by a sander and sent to the surface dry shaving silo for transient storage.
3. Adjust the rubber gum gluing section. The qualified surface layer dry shavings are separately sent to the mixing machine after being transported by the conveyor and the shaving metering silo. At the same time, the glue is sent to the mixing machine, and the shavings and glue are in the watch core. Under the full agitation of the layer mixing machine, the effect of uniform mixing and sufficient sizing is achieved.
4, paving hot pressing forming section (annual production of more than 30,000 production lines). The sizing after shaving is sent to the mechanical graded paving machine by the belt conveyor, and the evenly leveled slab is laid by the mechanical graded paving unit. The slab is sent to the loading cage of the loading machine through the permanent magnet separator, pre-pressing machine, longitudinal sawing machine, cross-cut saw, accelerating transporter, weighing conveyor and storage conveyor, loading conveyor, etc. The slab is sent to a multi-layer hot press for hot press forming, and the hot-formed bristles of the multi-layer hot press are simultaneously pushed into the unloader by the loading tray.
5. Post-processing section. The board staying in the unloader is sent to the cooling inboard conveyor by the unloading conveyor, and is sent to the cooling machine by the cooling inboard conveyor for cooling. The board after staying (cooling) in the cold plate machine is sent to the cross-cutting side cutting machine by the cooling plate conveyor to be cut and divided, and finally transported to the lifting platform by the dry plate conveyor.
6, sanding section. The cooled stacked particleboard is sent to the sanding production line for sanding, sorting and storage.
Semi Trailer,Tank Car Semi Trailer,Liquid Oxygen Semi Trailer
Linqu Hengchang Chemical Co., Ltd. , http://www.hcammoniasolution.com